Brighto All Weather (Acrylic Based)
Brighto All Weather is used for new or previously painted exterior masonry surfaces such as brickwork, plaster and cement rendering.
1L, 4L, 16L
See appropriate shade card
Depends on temperature, humidity, air movements and film thickness
Touch dry: 2 - 3 Hours
Recoat 6 - 8 Hours
Brush or Roller: 10-25% for Brush or Roller
Conventional spray: 30 - 40 % for Spray
Clean all equipment with water after use.
Conventional Spray Satisfactory through most equipment
New, bare, old or previously painted surfaces must be clean, dry and free from dust or wax. Clean the surface by rubbing down with abrasive paper. Brush down previously painted surface completely and make the surface smooth. For large holes and cracks, use plaster of Paris or white cement. Allow to dry. Rub down the surface with abrasive paper. Apply Brighto Exterior Primer in order to seal the surface from water and salts and allow to dry. Apply Brighto Exterior Filler and allow to dry. Rub down the surface with abrasive paper and dust off. Now the surface will be smooth and ready for Brighto All Weather to be applied. Stir the paint thoroughly before use.
Water Resistance:- Resistant to the levels of atmospheric humidity present in normal environments.
Pigment: Lightfast Pigments
Binder: Acrylic Copolymer Emulsion.
White 40 ± 2% (nominal), other colours will vary
FILM THICKNESS/COAT :
Wet: 75 - 100 Micrometers
Dry : 30 - 40 Micrometers
The spreading capacity of this product will vary considerably according to the roughness and porosity of the surface.
On smooth surface of average porosity 10-14m2 /liter /coat.