PRODUCT NAME:
Brighto Metallic Enamel

USAGE:
Brighto Metallic Enamel is used on all types of interior and exterior wood and metal surfaces.

COLOUR RANGE:
See appropriate shade card

DRYING TIMES:
Depends on temperature, humidity, air movements
and film thickness
Touch Dry                3  -  5      Hours  
Hard Dry (Recoat)     16 - 18  Hours   

PRACTICAL COVERAGE:
A guide to the practical coverage which can be achieved
under normal conditions is 15 – 17 m² /liter /coat.

APPLICATION:
Spray

CLEANING UP:
Clean all equipment with Mineral turpentine/Super Petrol immediately after use.

SURFACE PREPARATION:
New, bare, old or previously painted surfaces must be clean, dry and free from wax, dust, rust and all unwanted material.Clean the surface by rubbing down with abrasive paper. Brush down previously painted surfaces and dust off.Apply Brighto Red Oxide Primer on all metal surfaces in order to prevent from rust. Apply Brighto Undercoat on all Wooden surfaces.Apply Brighto Grey Oil putty on all automobile surfaces. Allow the Surfaces to dry completely. Stir paint thoroughly before use.

SYSTEM INFORMATION:
Wood
Metal
Automobile

THINNING:
Conventional spray 20 - 25 %

COMPOSITION (nominal):
Pigment: Lightfast Pigments
Binder:    Alkyd Resin
Solvent:  Mineral Turpentine/Super Petrol

VOLUME SOLIDS:
42 ± 2% (nominal), colours will vary

FILM THICKNESS/COAT:
Wet:  60 – 75 Micrometers
Dry :  25 - 35   Micrometers

FLASH POINT:
38^oC Degree