PRODUCT NAME:
Brighto Super Emulsion

USAGE:
Brighto Super Emulsion is used for all normal interior masonry surfaces including brickwork, Plaster, cement and wallboards.

PACK SIZE:
0.91L, 3.64L, 14.56L

COLOUR RANGE:
See appropriate shade card

DRYING TIMES:
Depends on temperature, humidity, air movements and film thickness
Touch Dry:       2 - 3 Hours    
Recoat:           5 - 6 Hours     

APPLICATION:

• Brush
• Roller
• Spray

THINNING:
Brush or Roller or Spray 10 - 50% depending upon application methodology


SURFACE PREPARATION:
New ,bare, old or previously painted surfaces must be clean, dry and free from dust or wax. Clean the surface by rubbing down with abrasive paper. Brush down previously painted surface completely and make the surface smooth. For large holes and cracks, use plaster of paris or white cement .Allow to dry. Apply Brighto Super Sealer in order to seal the surface from water and salts. Allow surface to dry completely. Then apply Brighto Super Filler and allow to dry. Rub down the surface with abrasive paper and dust off. Now the surface will be smooth and ready for Brighto Super Emulsion to be applied. Stir the paint thoroughly  before use.

SYSTEM INFORMATION:

• Powdery surfaces,
• Alkaline and new surfaces,
• Normal, sound surfaces

PRACTICAL COVERAGE:
A guide to the practical coverage which can be achieved under normal conditions is           
10 - 14m² /liter /coat.

SPRAY RECOMMENDATIONS:
Conventional Spray Satisfactory through most equipment

FILM PROPERTIES
Water resistance   
Will tolerate the levels of atmospheric humidity present in normal environments.

COMPOSITION (nominal):
Pigment: Lightfast Pigments
Binder:    PVA copolymer Emulsion
Solvent:  Water

VOLUME SOLIDS:
White 42 ± 2% (nominal), other colours will vary.

FILM THICKNESS/COAT:
Wet:  75 - 100  Micrometers
Dry :  30 - 44   Micrometers