PRODUCT NAME:
Brighto Wall Emulsion

USAGE:
Brighto Wall Emulsion is used  normal interior masonry surfaces including brickwork, Plaster, cement and wallboards.

PACK SIZE:
3.64L,14.56L

COLOUR RANGE:
See appropriate shade card   

PRACTICAL COVERAGE:
A guide to the practical coverage which can be achieved
under normal conditions is 10 - 14m² /liter /coat.

APPLICATION:
Brush        
Roller           
Spray

SPRAY RECOMMENDATIONS:
Conventional Spray       
Satisfactory through most equipment.

CLEANING UP:
Clean all equipment with water immediately after use.

SURFACE PREPARATION:
New ,bare, old or previously painted surfaces must be clean, dry and free from dust or wax. Clean the surface by rubbing down the abrasive paper. Brush down previously painted surface completely and make the surface smooth. For large holes and cracks ,use plaster of paris or white cement .Allow to dry. Apply Brighto Super Sealer in order to seal the surface from water and salts. Allow surface to dry completely. Then apply Brighto Wall Putty and allow to dry. Rub down the surface with abrasive paper and dust off. Now the surface will be smooth and ready for Brighto Wall Emulsion to be applied. stir the paint thoroughly  before use.

SYSTEM INFORMATION:
Powdery surfaces
Alkaline and new surfaces
Normal, sound surfaces
(Previously painted)

THINNING
Brush or Roller or Spray 10 - 50% depending upon application methodology

DRYING TIMES:
Depends on temperature, humidity, air movements and film thickness
Touch Dry               2 - 3 Hours    
Recoat                    5 - 6 Hours

FILM PROPERTIES:
Water resistance: Will tolerate the levels of atmospheric humidity present in normal environments.

COMPOSITION (nominal):
Pigment: Lightfast Pigments
Binder:    PVA copolymer Emulsion
Solvent:  Water

VOLUME SOLIDS:
White 41 ± 2% (nominal), other colours will vary.

FILM THICKNESS/COAT:
Wet:  75 - 100 Micrometers
Dry :  29 - 43  Micrometers